About receiver's Working Mode:
Manual On/Off:Press the receiver's Learning button, the receiver's relay is ON; press button again, the receiver's relay is OFF.
Momentary mode:Press the Remote control button, the receiver's relay is ON; release button, the receiver's relay is OFF.
Toggle mode:Press Remote control button for 1 time, the receiver's relay is ON; press button again, the receiver's relay is OFF.
Latched mode:Press Remote control button A, the receiver's relay is ON, Press the transmitter's button B, the receiver's relay is OFF.
Setting power-OFF memory:
When the power of the receiver is disconnected, the status before the power disconnection of the receiver will be recorded. When the power is restored, the receiver will return to the status before the power disconnection.
(For example: before the power is disconnected, the receiver is off, and the receiver will remain off after the power is restored;Before the power is disconnected, the receiver is turned on, and the receiver will automatically turn on when the power is restored. )
Reset function:After push the receiver's learning button 8 times, the receiver Clear all the remote control data in its memory.
When the red LED flashes for a few times, it indicates that the clear function is completed.
(After cleared the code in the receiver, all the remote control cannot work with the receiver.)
Matching method:
1.Manual On/Off:
Press the receiver's Learning button 1 time,The receiver will turn on the relay and the circuit will be connected.
Press the receiver's Learning button again,The receiver will disconnect the relay and disconnect the circuit.
2. Setting Toggle Mode (Common working mode):
Press the receiver's Learning button 2 time, the receiver's red LED will be lights up, it comes into Setting state; Press the remote's button, the receiver's red LED will flash then come off, Setting successfully.
3. Setting Latched Mode:
(Note: When you choose "Latched Mode", you need to setting two different buttons on the Remote control, the first time learn is for “ON”, the second time learn for “OFF”.
For example: button A = ON, button B = OFF)
Press the receiver's Learning button 3 time, the receiver's red LED will be lights up, it comes into Setting state; Press the remote's A button, the receiver's red LED will flash and then remains lit; Then press the remote's B button, the receiver's red LED will flash then come off, Setting successfully.
4. Setting momentary Mode:
Press the receiver's Learning button 4 time, the receiver's red LED will be lights up, it comes into Setting state; Press the remote's button, the receiver's red LED will flash then come off, Setting successfully.
5. Setting power-off memory
Press the receiver's Learning button 6 time, the receiver's red LED will be Flashing,the relay will energises the circuit.The setting is completed.
Note:
A Smart Switch can only store 12 buttons (on the remote). Saved button number of more than 12, it will cause all of the stored remote control cannot control the Smart Switch. You need reboot the power and reset the RF remote control settings (press the Smart Switch's matching button 8 times)
How to install this smart switch:
